1. Clean up the surroundings and countertops of the push table saw.

2. Check whether the saw blade is sharp and whether the large and small saw blades are on the same line

3. Test machine: The time is about 1 minute to see if the machine is running normally. Check the direction of rotation of the large and small saw blades to ensure that the direction of rotation of the saw blades is correct.

4. Put the prepared sheet on the push bed and adjust the gear size.

5. Start cutting.

Note that A. The plate should be close to the block and cannot be moved.;

B. Adjust the cutting speed according to the thickness and hardness of the sheet, and advance the machine tool at a uniform speed, not too fast or too fierce.

C. When opening small materials, apply wooden strips to press and advance.

D. Operators must wear masks, no gloves, no loose clothes, and no long hair.

E. You cannot directly use your hands to pick up objects next to the rotating saw blade. If necessary, you can use other long accessories to push it away before taking it.

6. If the corners of the opened plate are defective, the saw blade should be replaced.

7. After the cutting task is completed, turn off the power and do a good job of the saw table and the surrounding 5S.