Today, the manufacturer of the sliding table saw guiding rule will explain the debugging method of the sliding table saw:

1. Check the saw blade

The saw blade shall be free from chipping and excessive wear.

2. Determine the position of main saw and carving saw

① . The main saw and the carving saw are on the same line;

② . The main saw blade exceeds the workpiece by 20mm - 25mm;

③ . The carving saw exceeds the workpiece by 3mm to 5mm;

④ The main saw blade rotates clockwise and the carving saw rotates counterclockwise.

3. Trial saw a scrap board

The waste board shall be free of defects such as edge collapse, blackening and obvious steps.

Pushing table saw operation blanking - plate removal

Contact the forklift operator to place the required processing base materials on the left side of the sliding table saw and place them neatly.

When placing the plate, the cushion under the plate shall be flat and free from bending deformation of the plate.

Pushing table saw operation blanking - plate placing

Lift the base material onto the operating platform of the sliding table saw, and keep one side close to the parallel ruler to ensure that the cutting is parallel.

2. Put the useless surplus materials into the waste truck, and place the useful surplus materials reasonably for the convenience of subsequent use.

Pushing table saw operation - blanking and sizing

① Saw off the two sides of the plates placed in parallel to ensure that the plates are parallel.

② According to the size of the plate, use a ruler to press the block to limit the position.