There are three factors that have a decisive influence on the table saw: the guide rail, the balance of the saw car, and whether the large and small saw blades are on the same straight line. The impact of these three elements is explained and analyzed as follows:

1: Guide rail: The guide rail has a circular guide rail and a square guide rail, and its effect can be compared with the effect of a railway track. The difference is that the push table saw car caused by the work is much more stable than the train, and the guide rail of the push table saw Balance is not possible, which will directly affect the straightness of the sawed sheet. In other words, the hardness of the guide rail of the push table saw determines the result of the sawing work. If the hardness is not possible, the guide rail will be deformed, which greatly affects the cutting accuracy.

2: The balance and stability of the saw car's work is also the primary factor affecting the cutting effect. When the cutting effect is found to be unsatisfactory, the question of cleaning the guide rails is to check the balance of the saw car. The primary center of its composition is It is the shaft (bearing, saw shaft, locking slider). The first element to check should be to check the wear condition of the copper wheel, whether there is a different degree of wear that causes the saw car to work unstable.

3: Whether the large and small saw blades are in the same straight line, the working order of the push table saw is, the small saw opens the way, and the large saw cuts. If the two saws are not in the same direct line, there will be inconsistencies in the cutting and cutting, and the parking should be adjusted immediately when found. .