How to solve the phenomenon that the upper edge of the push-table sawing board appears, the lower edge appears (the board after sawing), there are scorch marks (on the board after sawing), and the workpiece is lifted by the auxiliary saw during sawing? The following is a detailed introduction for you:

1. The upper edge of the table saw appears violent

a. The main saw blade is too blunt and the teeth are too few

b. The main saw blade is too little higher than the plate

c. The quality of the plate is too poor, and the saw blade will be dull soon

d. Replace the saw blade

e. Raise the main saw blade

f. Select the plate with less impurities and high quality

2. The bottom edge of the push table saw appears (the board after sawing)

a. The auxiliary saw blade is too blunt

b. The width of the auxiliary saw is not enough and too narrow

c. The center lines of the main and auxiliary saw blades do not coincide

d. Replace the saw blade

e. Change the saw blade or increase the thickness of the saw blade

f. Re-adjust the left and right position of the auxiliary saw

3. There are scorch marks on the push table saw (on the board after sawing)

a. The saw blade is too dull and there are too many teeth on the saw blade

b. The speed is too high or the feed is too slow

c. Replace the saw blade and choose the appropriate saw blade

d. Select the appropriate rotation speed and feeding speed

4. When the push table saw is sawing, there is a phenomenon that the workpiece is pushed up by the auxiliary saw

a. The auxiliary saw blade is too blunt

b. The auxiliary saw blade is raised too high

c. Replace the saw blade

d. Appropriately reduce the height of the auxiliary saw blade