We have introduced the sliding table saw in detail before, and we also know what it is used for. However, there are many things that need to be paid attention to during the operation of this device, which everyone does not understand. Here is a brief introduction for you. If you want to know, come and take a look. Hope it can help you.

　　There are many knowledge points that need to be understood before using the sliding table saw. For the staff, you need to know the parameters of the sliding table saw. The specifications of the sliding table saw have become a series, the main parameters are large saw plus length, the general range is 2000 ~ 5000ram. In my country's industry standard JB/T9950-1999, T3 specifications are 2000mm, 2500mm, and 3150mm. In the future, everyone will choose according to their own needs when buying. What we should pay attention to when using it is to clean the surrounding and table surface of the sliding table saw. Then check whether the saw blade is sharp and whether the large and small saw blades are in a line. The next thing you have to do is to test the machine. The time is about 1 minute, but you can check whether the machine is running normally, check the direction of rotation of the saw blades, and make sure that the direction of rotation of the saw blades is correct. Then put the prepared plate on the pusher, and adjust the size of the gear. After all these tasks are completed, you can start cutting. During this process, you need to pay attention to the fact that the plate should be close to the block and cannot be moved. The staff should adjust the cutting speed according to the thickness and hardness of the plate, and advance the machine at a constant speed, not too fast or too violently. These are the matters that must be paid attention to when operating the sliding table saw.